Fiat 500 Replacement Key Fob

It may be time to replace the battery if the 500 remote key fob isn't working. If you do replace the battery and it does not work then the issue is likely to be elsewhere.

At United Locksmith, we specialize in the creation of new keys for classic automobiles. We have all of the tools and parts necessary for this type of service.

Dead Coin Battery

The most common reason your Fiat 500 key fob will not lock or unlock the doors is due to a dead battery. The key fob is equipped with an internal battery called a coin cell that is prone to draining quickly if it is not utilized frequently enough. If your remote starts to show signs of a loss of range or has stopped working or not responding, then the battery could be dead.

Metal clips keep the battery in inside the key fob. If the clips aren't tight, they can cause contact problems that will prevent your remote from receiving power. By using a small flathead screwdriver, break the clip that holds the retaining pin open to take out the battery and insert a new one. Be sure to use an alternative battery that has the same kind of voltage, size and specifications as the original battery.

Water exposure can also cause the key fob to corrode or become damaged. Even a small bath in warm, soapy water could cause damage to the chip. It is recommended to keep your key fob in a dry area.

Water Damage

If your key fob isn't operating properly, it may be caused by water damage. Key fobs are fitted with rubber seals that protect them from being damaged by rain or splashes of water, however it is crucial to keep your keys from being tossed into the pool, ocean, and the washing machine!

The key fob contains an electronic chip inside that sends a signal car's immobilizer system. The chip is what allows the 500 to start and lock. If it gets wet, however it will not function.

If you're looking to determine whether your key fob still working it is possible to clean the internal electronics with isopropyl or an electronic cleaner. It is recommended to replace a key fob if it is submerged in salt water instead of trying to repair it yourself.

A replacement fiat key fob could cost you some money, but it's a lot less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! Plus, you can do it yourself with the simplest of steps. Make sure you have the correct type of battery before you attempt to open your key fob. This task is much simpler than it appears and there are step-by-step instructions online for nearly every key fob in your car.

Faulty Chip

The chip in the key fob communicates directly with the immobiliser in your car to ensure that your vehicle will only start when correct keys are inserted. If the chip is damaged, or damaged in any way, your car will not start.

A chip that is defective can happen due to many reasons, but most commonly due to water damage or a dead battery. It is recommended to leave the repair to a professional locksmith who can repair the chip in a short time and at a a reasonable price.

If your key fob fails to function after exposure to clean water from the tap or rain, take out the battery and clean the electronic component with a towel to ensure it is fully dry before putting it back in. If the key fob still fails to work, it is likely an issue with the chip and is required to be replaced.

Many people will seek out their dealer when in need of a new fiat 500 stolen without keys key fob, but it can be a costly option. United Locksmith is the best option if you would like to have your Fiat keyfob repaired at a reasonable price. We have the tools and experience needed to fix your fiat 500 key fob not working (just click the following webpage) fob in a timely and professional manner.

Faulty Receiver Module

fiat punto car key key fobs send an electrical signal to the vehicle, which will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. There are several reasons why the fob might not function. These include a dead coin battery water damage, worn buttons, a receiver module issue or signal interference, or an electronic chip that has failed.

If the fob was in the pocket of someone who has suffered extreme trauma (such as being dropped onto the floor, or washed in the washer) the fob may not be in a position to communicate with the Body Control Module (BCM) of the vehicle. The BCM is a security system that will only accept signals from genuine keys.

If this is the case, then you have to replace your fob. A professional locksmith will handle the entire process of replacing your key including programming a new one for your 500. They can even give you a clone fob that works exactly like the original (and costs just a fraction of the cost).