Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a bit but it's still attractive. It's not the most luxurious car in its class, but it is a pleasant and peaceful driving experience.

We often get asked at Coded Car Keys to replace peugeot key fobs. No matter if the issue is ongoing or continuous, the following tips should aid.

Water Damage

If you accidentally drop your key fob into the puddle, or it is wet while kayaking, canoeing or rafting or canyoning it is likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry container when you're outdoors or performing activities that require the fob to be exposed to large amounts of water.

It's also important to make sure that the fob has dried out before you open it to use it again. If you smell any odors emanating from the fob (such as industrial liquid or windshield washer fluid) It's another indicator that it is submerged.

A wet circuit board can cause the battery to discharge its charge or even explode. If you are able to get your keyfob 308 out of the water you need to turn the button side up and shake as much water out as possible before opening the casing. After opening it, remove the battery and clean the circuit board using a cotton swab dipped in 90-percent isopropyl alcohol.

Other reasons why your peugeot replacement key 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module issues signal interference, or a faulty chip. If none of these is the issue, try resetting the system by disconnecting the battery that is 12 volts for about 15 minutes.

Dead Coin Battery

peugeot 508 key programming cars are equipped with a remote-start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to getting in. This feature is extremely useful particularly in cold winter months. However, sometimes the remote stop system stops operating due to a range of reasons, including an unresponsive coin battery.

The coin-shaped battery that is inside the key fob can last between two and four years based on how to get a new peugeot car key often it's used, where it was purchased, and how it is utilized. The date for use-by is typically printed on the packaging or marked in the manual.

If the key fob stops working after exposure to clean tap water then you must remove the battery, clean the chip using a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it could have fried the chip. It is recommended to replace it.

If you're unsure whether the battery is damaged, you can check its voltage using a multimeter connected to both the terminals for plus and minus. The voltage should read approximately 12 to 13 volts, but if it is lower, then the battery needs to be replaced. Alternately, you could try to reset your on-board computer by disconnecting the battery at 12 volts for a short period of time, and then reconnecting it in reverse order (positive cable first and then negative). The engine should start.

Faulty Receiver Module

If you don't get the "Key Detected" message, it could mean the receiver module faulty. It's the part that transmits an indication to the car when the key fob is activated, that also acts as an immobiliser, and stops it from starting unless the correct key is used.

This could result from a variety of causes, such as water damage or simply ageing. If your Peugeot 308 key fob has been exposed dirty tap water, as in the chip that is located inside is damaged. In this instance it is necessary to take it apart and thoroughly clean it with isopropyl alcohol or electronic cleaner. Once the battery has dried you can try it again.

If the issue persists, it is recommended to consult an area Peugeot expert or locksmith. They'll utilize a diagnostic tool to identify the issue and fix it.

Losing your Peugeot car keys can be a stressful experience. A professional auto locksmith can solve the issue in minutes. They can program your vehicle and cut a new functioning key for you. Click here to find a local locksmith near you.

Faulty Electronic Chip

The chip in the Peugeot 308 key fob plays a crucial role in the remote control system. If it becomes damaged, your car may not start, or you could receive a message saying "anti-theft active". In this situation, the only solution is to replace the key. Professional auto locksmiths can provide this fastest possible time.

The chip in the chip of your peugeot 208 spare key 308 key fob can fail due to sweat, water damage dirt, or other causes. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned right away. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. After that, you should let the battery dry completely.

Sometimes, a key fob can be inoperable due to radio interference. This can happen when other devices operate on the same frequencies as your Peugeot keyfob. This could be due to unsafe conditions or objects that are close to the vehicle. If you experience this problem it is recommended to visit the Peugeot dealership.

The Peugeot key fob 207/308 is extremely delicate and requires extra attention. It is crucial not to drop or throw the key fob. If you lose something, try to find it as soon as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Make sure you disconnect the negative first, and then the positive.