Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a bit, but it still feels eye-catching. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can help whether the problem is constant or intermittent.

Water Damage

If you happen to leave your key fob in a puddle or splash it with water while swimming, kayaking, canoeing, rafting or canyoning, it's more likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry container when you're outside or performing activities where the fob could be exposed to high levels of water.

You'll also need to make sure that the fob is completely dry prior to opening it and re-using it. If you notice any odors emanating from the fob like an industrial-like liquid smell or that of windshield washer fluid, it's another sign that it's submerged in water.

A circuit board that is wet could cause the battery to discharge its charge, or even explode. If you're able to fish the 308 key fob of the water body it got stuck in, flip the button side down and shake out as much water as you can before opening the case. Take the battery out, and then clean the circuit board using a cotton swab that is dipped in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not function include a dead battery in the coin-cell, receiver module problems, signal interference or a damaged chip. If none of these causes the cause, you can try resetting the system by disconnection of the 12 volt battery for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to getting in. This feature is extremely beneficial particularly during the cold winter months. Remote start systems may not function due to a variety of reasons, such as the battery being dead.

The coin-shaped battery inside the key fob could last between two and four years, based on how frequently it is used, the location it was purchased, and how it is utilized. The date for use-by will be displayed on the packaging or in the user manual.

If the key fob stopped working after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip completely before replacing it. If the key fob has been exposed to soapy or salty water, it could have caused the chip to be damaged. You'll need to replace it.

If you're unsure if the battery is faulty it is possible to test its voltage with a multimeter set to the car's voltage range and connected to the minus and plus terminals. The voltage should range from 12 to 13 volts, however, if it reads lower, the battery needs to be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has created a fault. It is the part which sends out the signal when your key fob activates. It also functions as an alarm, and stops the car from starting without the correct key.

It could be due to various causes, such as water damage or just getting old. If your Peugeot 308 key fob has been exposed dirty tap water, like the chip that is located inside is damaged. In this case, you'll need to take the device apart and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the issue is not resolved, it is recommended that you visit the local Peugeot expert or locksmith. They can utilize a diagnostic tool in order to identify the issue and repair it.

Losing your Peugeot keys to your car is an emotional experience. A qualified auto locksmith can solve the issue in minutes. They can cut a new key and program it to your vehicle, making sure you're back off the road in the shortest amount of time. Click here to find a locksmith near you.

Faulty electronic chip

The electronic chip that is in your Peugeot 308 key fob is an vital component of the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message that says "anti-theft". If this occurs, the only way to fix the problem is to get a new key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest amount of time.

The chip in the chip of your peugeot 208 key programming 308 key fob can be damaged by water damage, sweat, dirt or other reasons. If your peugeot 308 key (recent willysforsale.com blog post) fob is exposed to soapy water, it is recommended to clean it right away. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. The battery must then be allowed to dry completely.

Sometimes keys can stop working because of radio interference. This can happen when other devices use the same frequency as your Peugeot keyfob. This could be due to bad conditions or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you have this problem.

The Peugeot 207/308 key fob is extremely delicate and requires extra attention. It is crucial not to drop or throw the key fob. If you lose it, try to locate it as quickly as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a few minutes. Disconnect the negative cable prior to the positive.